TROUBLESHOOTING CHART
PROBLEM CAUSE CORRECTION
Starter rope hard 1. Engine flywheel brake is on I. Depress control bar to
topull when control bar is release( upper handle before
pulling starter rope.
2. Bent engine crankshaft. 2. Contact a Sears or other
qualified service center.
3, Blade adapter broken. 3. Replace blade adapter.
4. Blade dragging in grass. 4. Move lawn mower to cut
grass orto hard surface.
Sraas catcher 1. Cuttingheight too low. 1. Raise cutting height.
_otfllllng (ifao 2. Lifton blade worn off. 2. Replace blade.
Klulpped ) 3. Catcher not venting air. 3. Clean grass catcher.
!Hardtopush 1. Raise cutting height.1. Grass istoo high or wheel
height is too low.
2. Rear of lawn mower
housing or cutting blade
dragging in grass.
3. Grass catcher too full.
4. Handle height position not
dght for you.
2. Raise rear of lawn mower
housing one (1) setting
higher,
3, Empty grass catcher.
4. Adjust handle height to suit.
17
To Next Page
Loading...
