TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEM CAUSE CORRECTION
6 Worn, bent or loose blade.
6 Replace/sharpen blade. Tighten
blade bolt.
7 Buildup of grass, leaves and
trash under mower.
8 Mower drive belt worn.
9 Blades improperly installed.
10 Improper blades used.
7 Clean underside of mower
housing.
8 Replace mower drive belt.
9 Reinstall blades sharp edge down.
10 Replace with blades listed in
this manual.
11 Clogged mower deck vent holes 11 Clean around mandrels to
from buildup of grass, leaves, and open vent holes.
trash around mandrels.
Headlight(s) not 1 Light switch is "OFF". 1 Turn light switch "ON".
working
(if so equipped) 2 Bulb(s) or lamp(s) burned out. 2 Replace bulb(s) or lamp(s).
3 Faulty light switch. 3 Check/replace light switch.
4 Loose or damaged wiring. 4 Check wiring and connections.
5 Blown fuse. 5 Replace fuse.
Battery will not 1 Bad battery cell(s). 1 Replace battery.
charge 2 Poor cable connections. 2 Check/clean all connections.
3 Faulty regulator (if so equipped). 3 Replace regulator.
4 Faulty alternator. 4 Replace alternator.
Engine "backfires" 1 Engine throttle control not se 1 Move throttlecontrolbetween
when turning between half and full speed (fast' half and full speed (fast) position
engine "OFF" position before stopping engine before stopping engine.
Engine dies when 1 Reverse operation system (ROS) 1 Turn ignition key to ROS "ON"
tractor is shifted is not "ON" while mower or other position. See Operation section.
attachment is engaged.
into reverse
o F]nd this and a[[ your other product manuals on[]ne.
o Get answers from our team of home experts.
o Get a personalized maintenance plan for your home.
o Find information and tools to help with home projects.
manage home
32
To Next Page
Loading...
Need help?
General
