Craftsman 950156 - SAFETY INSTRUCTIONS; ASSEMBLY; TO ASSEMBLE THE TWO PIECE HANDLE; TO ASSEMBLE THE HANDLE INTO THE SOCKET

• Study, understand, and follow all
instructions with and on this device
before operating this device.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• This is a lifting device only. Immediately
after lifting, support the vehicle with
appropriately rated vehicle stands.
• Do not move or dolly the vehicle while
on the jack.
• Failure to heed product markings or
warnings may result in personal injury
or property damage.
Leer, comprender, y seguir las instrucciones
antes de utilizar el aparato. El manual
de instrucciones y la informacion de
seguridad deben estar comunicado en
lengua del operador antes del uso. No
seguir estas indicaciones puede causar
danos personales o materiales.
To avoid crushing and
related injuries:
NEVER work on,
under or around a load [
supported only by jack.
ALWAYS use adequately
rated jack stands.
! SAFETY MESSAGE !
Be sure all tools and personnel are clear
before lowering load. No alterations
shall be made to this product. Only
attachments and/or adapters supplied by
the manufacturer shall be used. Lift only
on areas of the vehicle as specified by the
vehicle manufacturer.
NOTE: Jack stands are rated per pair
unless otherwise noted.
Use 1 matched _ per vehicle only.
A T _, v
TO ASSEMBLE THE TWO PIECE
HANDLE
• Locate the spring pin on bottom end of upper
handle and the spring pin receiver on the
upper end of lower handle. (Fig. 1).
• Align the spring pin with the spring pin
receiver. Connect the two handle pieces
together by pressing the spring pin and
insert until the spring pin is locked in the
spring pin receiver.
TO ASSEMBLE THE HANDLE INTO
THE SOCKET
1. Press and hold the handle socket to loosen
the lock pin (Fig. 2).
2. Pull out the lock pin, then release handle
socket slowly.
,_l_Caution: Handle socket is spring loaded.
Beware of pinching on fingers during
removal of lock pin.
3. Pull and hold the spring knob (Fig. 3).
4. Insert the assembled handle into the
socket, until it is firmly seated.
5. Release spring knob to secure the handle
in position.
S/p,ring Pin
/ /Spring Pin Receiver
Upper Handle
Lower Han_dll
FIG. 1
FIG. 2
Handle Socket_
o / ®
hold the
"_"_'_.,_ positionof Handle
tL.(_] Socket in packaging)
Assembled _._, Handle Socket
Handle ---_ /_
Spring Knob ---______
FIG. 3