EasyManuals Logo

Craftsman CMCST910M1 User Manual

Craftsman CMCST910M1
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
7
ENGLISH
READ ALL INSTRUCTIONS
BATTERIES AND CHARGERS
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
proceduresoutlined. When ordering replacement battery
packs, be sure to include the catalog number andvoltage.
The label on your tool may include the following symbols. The
symbols and their definitions are asfollows:
V ......................... volts
Hz .......................hertz
min ..................... minutes
or DC ......direct current
...................... Class I Construction
(grounded)
…/min ..............per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................watts
Wh ......................watt hours
Ah ....................... amp hours
or AC ...........alternating current
or AC/DC .... alternating or direct
current
...................... Class II Construction
(double insulated)
n
o
.......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... wear respiratory
protection
..................... wear eye protection
..................... wear hearing
protection
..................... read all
documentation
WARNING: Use of this tool can generate
and/or disperse dust, which may cause serious
and permanent respiratory or other injury. Always
use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away
from face andbody.
WARNING: Always wear proper
personal hearing protection that conforms
to ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this product
may contribute to hearingloss.
CAUTION: When not in use, place tool on
its side on a stable surface where it will not cause
a tripping or falling hazard. Some tools with a
large battery pack will stand upright but may be easily
knockedover.
Air vents often cover moving parts and should be
avoided. Loose clothes, jewelry or long hair can be caught
in movingparts.
Additional Safety Information
WARNING: Never modify the power
tool or any part of it. Damage or personal injury
couldresult.
WARNING: ALWAYS use safety glasses.
Everyday eyeglasses are NOT safety glasses. Also use
face or dust mask if operation is dusty. ALWAYS WEAR
CERTIFIED SAFETYEQUIPMENT:
ANSI Z87.1 eye protection (CAN/CSA Z94.3),
ANSI S12.6 (S3.19) hearing protection,
NIOSH/OSHA/MSHA respiratoryprotection.
WARNING: Some dust contains chemicals
known to State of California to cause cancer, birth
defects or other reproductive harm. Some examples of
these chemicals are:
compounds in fertilizers,
compounds in insecticides, herbicides
andpesticides,
arsenic and chromium from chemically
treatedlumber.
To reduce your exposure to these chemicals, wear
approved safety equipment such as dust masks that
are specially designed to filter out microscopicparticles.
the danger. To reduce the risk of rebound (ricochet) injury,
work going away from any nearby solid object such as wall,
steps, large stone, tree,etc.
USE GREAT CARE when working close to solid objects and
where necessary, do trimming byhand.
DAMAGE TO UNIT – If you strike or become entangled
with a foreign object, stop appliance immediately, remove
battery, check for damage and have any damage repaired
before further operation is attempted. Do not operate with
a broken hub orspool.
DO NOT OPERATE portable electric appliances in gaseous
or explosive atmospheres. Motors in these appliances
normally spark, and the sparks might ignitefumes.
STAY ALERT – Do not operate this unit when you are tired,
ill, or under the influence of alcohol, drugs, ormedication.
DO NOT immerse appliance in water or squirt it with
ahose.
DO NOT allow any liquid to get inside it. If appliance does
get wet, allow to dry for a minimum of 48hours.
DO NOT clean with a pressurewasher.
DO NOT store the appliance on or adjacent to fertilizers
orchemicals.
DO NOT charge appliance in rain, or in wetlocations.
STORE IDLE APPLIANCES INDOORS – When not in use,
appliances should be stored indoors in a dry, locked‑up
place out of reach ofchildren.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Craftsman CMCST910M1 and is the answer not in the manual?

Craftsman CMCST910M1 Specifications

General IconGeneral
BrandCraftsman
ModelCMCST910M1
CategoryTrimmer
LanguageEnglish

Related product manuals