Troubleshooting
Troubleshooting
PowerFlo ™ - Owner's Manual
20
Problem Solution
Unit Will Not Turn On The pump is not making any noise when switch is turned on.
o Check to make sure battery is charged.
o Check in-line fuses on wiring harness
o Replace if needed.
o Check to make sure electrical connections are secure
o If these steps do not generate results please contact
customer service 1-800-345-2231.
Pump is running but no water flow.
o Check lines for pinches or kinks.
o Remove and clean filter, tighten cap.
o Open two valves to allow air to escape.
o If there is still no water pressure please contact
customer service to order replacement parts.
Leaking Valves Check threads at connections for cracks caused by over-
tightening. If no cracks make sure that all connections are
tight (hand tight) and try the unit again.
Leaking Manifold If a leak is on a threaded part, tighten the fitting finger tight.
Check for cracks in the fittings and around the hose
connections.
If a leak is between the glued parts, contact customer service.
Flat Tire Air up tire ( do not exceed 30 PSI). If significant pressure loss
occurs within 24 hours check for punctures or cracks.
If under warranty contact customer service for warranty repair.
Pump Back Plate
Broken
Must be replaced…contact customer service.
To Next Page
Loading...