Heater Settings
Power Off: Heater power and all functions are off.
Flame Setting: Flame effect is on. NO HEAT IS EMITTED ON THIS SETTING.
LOW Heat Setting
: Flame effect and 750W heater setting are on.
HIGH Heat Setting: Flame effect and 1500W heater setting are on.
OVERHEAT PROTECTION
The heater has an internal, over-heating safety device which automatically switches the
heater off if an over-heat situation is detected. If this should occur, unplug the
appliance and wait until the unit cools off. Once the unit has fully cooled, you can switch
it on again.
To Reset the Heater
If your heater overheats for any reason, please do the following to reset.
1. Turn unit to off.
2. Unplug unit wait 5 minutes.
3. Plug in and turn on.
To Next Page
Loading...