5
8: HIGH: Use this control to adjust the high frequency response of the
amplifier. Rotating the control counterclockwise reduces the high fre-
quency output. Rotating the control clockwise increases the high fre-
quency output. The High control provides a range of 27dB of boost or
cut at 10kHz.
9: SPEAKER: Use this jack to connect the amplifier to an external speak-
er. The internal speaker is disconnected when this jack is used. The
impedance of the external speaker must be 4 ohms or greater!
WARNING: Do not use attempt to use headphones in the Speaker
jack! Permanent hearing damage could result!
10: HEADPHONES: Use this jack to connect headphones to the amplifi-
er. The internal speaker is disconnected when headphones are used.
CAUTION: To avoid possible damage to your hearing, do not use
headphones for extended periods of time at extremely loud lev-
els.
11: ON LED: This LED illuminates when the amplifier is turned on.
12: POWER: Use this switch to turn the amplifier on (top of the switch
depressed) and off (bottom of the switch depressed).
13: POWER CORD (rear panel, not shown): The grounded power
cord should only be plugged into a grounded power outlet that meets all
applicable electrical codes and is compatible with the voltage, power,
and frequency requirements stated on the rear panel. Do not attempt
to defeat the safety ground connection.
To Next Page
Loading...
Need help?
General
