Creative Engineering ROCK-A-FIRE EXPLOSION - Page 175

c) RIPS in the latex: The cause of the latex ripping needs to be
located and corrected immediately.
Rips can be repaired by using 3M CA-40 Glue. It is important
that the ripped sections be lined up exactly. Once the
pieces are pushed together it will be to late to make any
corrections. Take precautions CA-40 will damage the fur and
paint on the latex parts. This procedure is not a
permanent repair, but allows time for a replacement part to be
obtained.
d) TONGUES, FINGER and TOE NAILS that have fallen off, can be
reglued with hot melt glue. Follow the same precautions as
above in step c. If any are lost or damage beyond repair, they
can be ordered from your parts catalog.
e) LATEX PAINTED, Parts that have worn areas, paint peeling
off, scratched, can be touched up using cotton swabs. Under
NO circumstances are large areas to be brushed painted. If an
artist is available, airbrushing the part would yield the best
results. The touch up paints can be ordered from your parts
catalog. There you will find the color you need, the part
number of the paint and where the paint is to be used.
f) FOAM, that has separated from itself, or has been damaged,
torn or pulled apart from latex, or any attaching devises,
can be repaired with 3M Weather Striping Cement Part #
95-010-030. Take precautions cement will be very
difficult to remove from fur or any painted parts.
3-138