Technical Specifi cations:
• Driver: 40mm Neodymium magnet
• Frequency Response: 15Hz ~ 22kHz
• Impedance: 32ohms
• Sensitivity (1kHz): 105dB/mW
• Noise Reduction Level: Up to 17dB (85%)
• Wireless Technology: Bluetooth v3.0
• Bluetooth Profi les: A2DP, AVRCP, HSP, HFP (HD Voice ready)
• Audio Codec: aptX, AAC, FastStream, mSBC, SBC
• Content Protection: SCMS-T
• Operating Frequency: 2402 ~ 2480 MHz
• Operating Range: Up to 10m / 33ft
• Power Supply: Rechargeable Lithium Ion battery, 3.7V, 620mAh
• Charge via USB: 5VDC, 500mA
• Charge / Play / Talk Time: 2 hours / 15 hours* / 21 hours*
• Net Weight: 292g / 10.3oz
FastStream allows low latency wireless bi-directional audio streaming and voice communication with
Creative BT-W1 Bluetooth USB transceiver. HD Voice requires supported handsets and mobile networks
* Without ANC
6. Left earcup indicator
7. Micro-USB charging
connector
8. Audio Input connector
9. Invisible Microphone
10. NFC (Near Field
Communication) pad
Blue and green blinks simultaneously: in an active Creative
ShareMe connection.
Red and fl ashes once: powering off the headset.
Red and blinks slowly: low battery level, charge the headset
soonest.
Red: charging headset. This goes off when headset is fully
charged.
Use the supplied USB cable for charging the headset via a
laptop or computer.
Use the supplied audio cable for a wired connection to non-
wireless devices or when battery power runs out. Connect the
smaller 2.5mm diameter plug to the headset (align the triangular-
shaped connector properly) and the larger 3.5mm diameter plug
to your audio device.
Noise suppression microphone for crystal clear communications
and environmental sensing microphones for ANC processing.
Tap your NFC-enabled mobile devices here to establish
Bluetooth pairing and connection. Tap again to end connection.
Connector / Port Function
To Next Page
Loading...
