5 - Effects
E-MU E-Wire VST
E-MU Digital Audio System 83
E-MU E-Wire VST
E-Wire is a special VST/ASIO Bridge which allows you to route digital audio via ASIO to
PatchMix and back again.
E-Wire VST incorporates smart time alignment technology that automatically compen-
sates for system latencies and ensures proper synchronization of audio throughout the
VST chain. In addition, E-Wire also allows you to insert outboard audio gear into the
VST environment.
E Note: It’s easier to use
E-MU PowerFX instead of
E-Wire if you just want to
use the hardware effects.
(E-Wire was the precursor
to E-MU PowerFX.)
However, E-Wire can be
very useful because it
allows you to route VST
inserts or Sends to
Physical Inputs and
Outputs via PatchMix DSP.
E-Wire has three main components:
•A VST plug-in which handles the audio routing to PatchMix DSP.
• An ASIO mixer strip in PatchMix DSP configured to route audio to the E-Wire
plug-in. You simply drop the effects you want to use into this strip.
•For hosts that don’t support automatic delay compensation, a manual delay-
compensation plug-in can be inserted in Cubase tracks or channels that don’t use
E-Wire to compensate for ASIO delay.
The diagram below may give you a better idea of how E-Wire works:
Stereo Reverb
ASIO Send
E-Wire VST plug-in
PatchMix DSP
Strip configured
for E-Wire
Send to Strip
Return to VST
E-Wire bridges the gap between hardware I/O and the VST world. The E-Wire VST plug-in sends
audio to a strip containing the desired effect. An ASIO Send routes the audio back to E-Wire VST.
To Next Page
Loading...