Cressi NEPTO - Dive-Set: Setting dive parameters. FREE; Taravana Protection Algorithm; Setting Dive Alarms

To Next Page

To Previous Page

ENGLISH

DIVE-SET : Setting dive parameters. FREE

Press

SEL

to enter the function, and UP /DOWN to set the level of protection desired. Then press

SEL

to conﬁrm.

Press

ESC

to exit the function.

SET THE PROTECTION COEFFICIENT BASED ON YOUR PHYSICAL AND MENTAL STATE.

After having set the MODE-SET (MODE-S) menu to FREE mode, you can activate or edit the alarms and notiﬁcations by accessing the DIVE-SET (DIVE-S) menu.

From the DIVE-S screen, press

SEL

to access the SET FREE menu. The available settings are:

Adjusting the Taravana protection algorithm (TARAV.), setting the warm-up dive (BLOODSH.), surface time warning (SURF-T), depth alarms (DEPTH AL1, AL2, AL3,

AL4, AL5), dive time warning (DIVE-T), depth interval alarm (STEP), hydration notiﬁcation (HYD),

water salinity adjustment (WATR), Logbook sampling frequency (LOG.-SAM.).

Taravana protection level (TARAV.)

Be setting the Taravana protection level, you will change the amount of recovery time suggested to reduce the risk of Taravana. The coefﬁcient can be set to eight

different levels, L1-L8. You can also set the coefﬁcient to OFF; in this event the watch will not provide any advice on recovery times.

NOTE: NEPTO is set to level L1 in the factory.

SEL ESC