Crestron DGE-100 Do Guide

DO GUIDE
DO Connect the Device
Make connections to the DGE-100 or DM-DGE-200-C using Crestron power supplies for
Crestron equipment.
NOTE: Connection to the included power pack is not required if PoE (Power over Ethernet) is
used to power the device. Use one or the other but not both at the same time.
DGE-100 Top Panel Connections
DGE-100 Bottom Panel Connections
DGE-100/DM-DGE-200-C
Digital Graphics Engines
DO Install the Device
The Crestron
®
DGE-100 and DM-DGE-200-C can be mounted onto a at surface or onto a rack
rail.
Mounting onto a Flat Surface
Using four mounting screws (not included), mount the device onto a at surface.
Mounting onto a Flat Surface (DGE-100 Shown)
Mounting onto a Rack Rail
Using two mounting screws (not included), mount the left or right mounting ange of the device
onto the front or rear rail of a rack.
Mounting onto a Rack Rail (DM-DGE-200-C Shown)
DO Check the Box
QTY PRODUCT COLOR PART NUM.
1 Cable, USB 2.0, A - Micro B, 6' (1.8 m) Black 2038114
1 Connector, 4-Pin 2003576
1 Connector, 5-Pin 2003577
Items for the DGE-100 Only
1 Power Pack, 24 Vdc 0.75 A, 100-240 Vac 2045865
Items for the DM-DGE-200-C Only
1 Power Cord, 5' 10" (1.78 m) 2042043
1 Power Pack, 24 Vdc 2.5 A, 100-240 Vac 2045873
HDMI
®
INPUT:
Digital Video and
Audio Input
HDMI OUTPUT:
To Display
USB:
To Touch Screen
LAN:
10BASE-T/100BASE-TX
Ethernet to LAN PoE
24 V 0.75 A:
From Power Pack
Ground
COM:
To RS-232 Device
USB:
To PC Running
Crestron Toolbox™ Software
IR:
To IR Controllable
Devices

Crestron DGE-100 Specifications

General

Brand	Crestron
Model	DGE-100
Category	Engine
Language	English