Crestron DM-MD8X8 - Page 175

Crestron DM-MD8X8/16X16/32X32 DigitalMedia™ Switchers
2. Select letters (upper and lower-case), numbers, or other characters by
turning the selection knob until the desired letter, number, or other character
is displayed on the LCD. Move the cursor to another position by pressing
the soft buttons labeled g
and h. To delete a character, press the soft
button marked Del.
NOTE: The maximum length for any input name is 32 characters.
3. After the new name has been entered, press Done to save the name and
return to the list of options for the input card.
Video Settings
The DMC-VID-RCA-D can display information about the video portion of the
incoming signal and adjust the picture. To view and/or adjust the video settings:
1. Turn the selection knob to highlight Video Settings and press the ENTER
button.
Video Settings
Video Settings
Input Type: Component
Video Type: Interlaced
Resolution: 1920x1080
2. Turn the selection knob to view information on input type, video type,
resolution, frame rate, and aspect ratio.
3. The picture settings can also be adjusted.
Picture controls can be used to adjust the picture’s brightness, contrast,
saturation, and hue levels. To adjust the picture:
a. Turn the selection knob to highlight Picture Controls and press the
ENTER button.
b. Turn the selection knob to highlight the picture control to be adjusted
and press the ENTER button. Controls are available for brightness,
contrast, saturation, and hue.
Operations Guide – DOC. 6755C DigitalMedia™ Switchers: DM-MD8X8/16X16/32X32 x
169