Crestron DM-MD8X8 - Outputs

Crestron DM-MD8X8/16X16/32X32 DigitalMedia™ Switchers
Input Setup
Input Setup
1. DMC-VID4 Security Cam
2. DMC-VID-RCA-D Analog
3. DMC-HD-DSP Advanced
3. To configure an input, turn the selection knob to highlight an input and
press the ENTER button.
For instructions on configuring a specific input card model, refer to
“Appendix B: Input Card Configuration” on page 90.
4. To exit the Inputs section and return to Installer Tools, press the MENU
button.
Outputs
The Outputs section of Installer Tools is used to view information about output cards
installed on the DM switcher. Any changes made to the Outputs section will be
saved upon exiting Installer Tools. For more information on exiting Installer Tools,
refer to “Exit Installer Tools” on page 42.
To open the Outputs section of Installer Tools:
1. Open Installer Tools as described on page 41.
2. Turn the selection knob to highlight Outputs and press the ENTER button.
A list of outputs will be displayed.
Output Setup
Output Setup
1. DMC-CATO-HD – CAT5
2. DMC-CATO-HD – CAT5
3. DMC-CATO-HD – CAT5
3. To configure an output, turn the selection knob to highlight an output and
press the ENTER button.
For instructions on configuring a specific output card, refer to “Appendix C:
Output Configuration” on page 175.
Operations Guide – DOC. 6755C DigitalMedia™ Switchers: DM-MD8X8/16X16/32X32 x
43