DM-NVX-E30(C)/DM-NVX-D30(C)/DM-NVX-D80-IOAV Product Manual – DOC. 8425B
To remove pairing between DM NVX devices, do either of the following:
• If automatic USB pairing is not enabled, trigger the <RemovePairing> digital
input join on each DM NVX device.
• If automatic USB pairing is enabled, do either of the following:
- For Layer 2, enter 00:00:00:00:00:00 or an empty string into the
<UsbRemoteDeviceId> serial input join.
- For Layer 3, enter an unused IP address into the
<UsbRemoteDeviceIpAddress> serial input join.
For additional information about configuration of USB routing, refer to the SIMPL
Windows help file.
Crestron XiO Cloud Service Connection
The Crestron XiO Cloud™ service allows supported Crestron devices across an enterprise
to be managed and configured from one central and secure location in the cloud.
Connection to the Crestron XiO Cloud service can be enabled or disabled using the
web interface.
Configure the connection to the Crestron XiO Cloud service on the Device page. In the
Cloud Settings section of the page, set Cloud Configuration Service Connection to
Enabled (default setting) or Disabled.
Device Page – Cloud Configuration Service Connection
When Cloud Configuration Service Connection is set to Enabled, connection to the
Crestron XiO Cloud service is allowed. For instructions about connecting to the service,
refer to the DM-NVX-E30/DM-NVX-D30 Quick Start (Doc. 8211), DM-NVX-E30C/
DM-NVX-D30C Quick Start (Doc. 8346), or DM-NVX-D80-IOAV Quick Start (Doc. 8526)
as appropriate. For information about using the service, refer to the Crestron XiO Cloud
User Guide (Doc. 8214). The documents are available at www.crestron.com/manuals.
To Next Page
Loading...
