Product Manual – DOC. 8879C DM-NVX-36x(C) Encoders/Decoders • 45
8. Do one of the following:
• If CEC is selected in step 4, enter the CEC command in the Power Off (No
Sync Detected) and Power On (Sync Detected) sections. If a custom
command is desired, enter the desired command, and then select the desired
terminator and format.
To test the command, click the Test button.
• If RS232 is selected in step 4, enter the RS232 command in the Power Off (No
Sync Detected) and Power On (Sync Detected) sections, and then select the
desired terminator and format.
To test the command, click the Test button.
• If Infrared is selected in step 4, click IR Ports under the Settings tab and then
click the
Load IR File button for port 1 or port 2. Browse to select and upload
the desired IR file.
For additional information, refer to the online help of the web interface.
To Next Page
Loading...
