Crestron HD Streaming Receiver and Room Controller 100 Do Guide

DO GUIDE
DO Make Connections to the Device
Make connections to the front and rear panels of the device as required for the application
(refer to illustrations  and ).
 Front Panel Connections
 Rear Panel Connections
NOTE: The Ethernet port ( ) is a PoE (Power over Ethernet) PD (Powered Device) port.
To receive PoE, the DM-RMC-100-STR requires connection to a PoE PSE (Power Sourcing
Equipment) port of a PoE switch. Any wiring that is connected to a PoE PSE port is for
intrabuilding use only and should not be connected to a line that runs outside of the building in
which the PSE is located.
NOTE: Connection to the included power pack is not required if PoE is used to power the
device.
DM-RMC-100-STR
HD Streaming Receiver and Room Controller 100
DO Install the Device
The Crestron
®
DM-RMC-100-STR can be mounted onto a at surface or onto a rack rail.
Mounting onto a Flat Surface
Using four mounting screws (not included), mount the device onto a at surface such as a wall
(refer to illustration ) or the underside of a table.
 Mounting onto a Wall
Mounting onto a Rack Rail
Using two mounting screws (not included), mount the left or right mounting ange of the device
onto a front or rear rail of a rack (refer to illustration ).
 Mounting onto a Rack Rail
DO Check the Box
QTY PRODUCT PART NUM.
1 Connector, 4-Pin 2003576
2 Connector, 5-Pin 2003577
1 Power Pack, 24 Vdc 0.75 A, 100-240 Vac 2045865
Not Included: Cables, Mounting Screws, USB Mass Storage Device
From Power Pack
(Included)
To/From
RS-232
Device
To IR
Controllable
Devices
To
HDMI
®
Display
From USB Mass
Storage Device
(For Firmware Loading)
Balanced/Unbalanced
Stereo Line Level
Audio Output
To /From
10BASE-T/100BASE-TX
802.3af PoE
Power Sourcing
Equipment

Crestron HD Streaming Receiver and Room Controller 100 Specifications

General

Brand	Crestron
Model	HD Streaming Receiver and Room Controller 100
Category	TV Tuner
Language	English