EasyManua.ls Logo

Crestron TSR-310 - Page 2

Crestron TSR-310
2 pages
Print Icon
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DO GUIDE
DOC. 8225C (2049522) 05.18
Specications subject to change without notice.
Congure IP Settings
To congure IP settings for the TSR-310:
1. Tap IP Settings on the Wireless Setup screen to display the IP Settings screen.
2. Tap On or Off under DHCP Enabled to enable or disable using DHCP (dynamic host
conguration protocol).
3. If DHCP is enabled, proceed to step 7. If DHCP is disabled, tap Set Static IP Settings to
display the Static IP screen.
4. Tap the elds under Static IP Address, Static Subnet Mask, Static Default Router,
Preferred DNS, and Alternate DNS to enter the required information using the on-screen
keypad.
5. Tap SAVE to save the new entry or tap CANCEL to discard any changes.
6. Tap < BACK on the Static IP screen to return to the IP Settings screen.
7. Tap Set Hostname on the IP Settings screen to display a screen for entering the TSR-310
hostname.
8. Tap the Enter Hostname eld to enter the TSR-310 hostname using the pop-up keyboard.
9. Tap SAVE to save the hostname or CANCEL to discard any changes.
10. Once all IP settings have been congured, tap Apply Changes on the IP Settings screen to
apply the new settings and to stay in setup mode.
11. Tap Reboot to exit setup mode and to reboot the TSR-310.
DO Congure IP Table Settings
To set up a connection between the TSR-310 and a control system’s IP table:
1. Tap IP Table Setup on the main setup screen. The IP Table Setup screen displays.
2. Tap Add/Edit to add or edit an entry. The Edit IP Table Setup screen displays.
3. Tap the text eld below CIP ID to enter the appropriate CIP ID using the on-screen keypad.
4. Tap SAVE to save the new entry or tap CANCEL to discard any changes and to return to the
Edit IP Table Setup screen.
5. Tap the text eld under IP Address / Hostname to enter the control system’s IP address or
hostname.
NOTE: Depending on the network conguration, using a static IP address may yield slightly
faster connections when the remote wakes.
6. Tap SAVE to save the new entry or tap CANCEL to discard any changes and to return to the
Edit IP Table Setup screen.
7. Tap SAVE to save the current entry or tap DELETE to clear it.
8. Tap < BACK to return to the main setup screen.
DO Set Up Voice Services
Voice services for the TSR-310 allows the user to control various device functions using voice
commands. For instructions on conguring voice services for the TSR-310, refer to the TSR-310
Supplemental Guide (Doc. 8226).
As of the date of manufacture, the product has been tested and found to comply with specications for CE marking.
Federal Communications Commission (FCC) Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Industry Canada (IC) Compliance Statement
CAN ICES-3(B)/NMB-3(B)
Crestron product development software is licensed to Crestron dealers and Crestron Service Providers (CSPs) under a limited non-exclusive, non-transferable Software Development Tools License Agreement. Crestron product operating system software is licensed to Crestron dealers, CSPs, and
end-users under a separate End-User License Agreement. Both of these Agreements can be found on the Crestron website at www.crestron.com/legal/software_license_agreement.
The specic patents that cover Crestron products are listed at www.crestron.com/legal/patents. The product warranty can be found at www.crestron.com/legal/sales-terms-conditions-warranties.
Certain Crestron products contain open source software. For specic information, visit www.crestron.com/legal/open-source-software.
Crestron, the Crestron logo, and Crestron Toolbox are either trademarks or registered trademarks of Crestron Electronics, Inc., in the United States and/or other countries. Wi-Fi is either a trademark or a registered trademark of Wi-Fi Alliance in the United States and/or other countries. Other
trademarks, registered trademarks, and trade names may be used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron is not responsible for errors in typography or
photography.
This document was written by the Technical Publications department at Crestron.
©2018 Crestron Electronics, Inc.
DO
Learn More
Visit the website for additional information and the latest rmware
updates. Instructional videos showing various installation procedures
can also be viewed. Use a QR reader application on your mobile
device to scan to the QR images, or click the QR images to load the
web pages. The instructional videos may also be accessed by visiting
vimeo.com/album/4939476.
Crestron Electronics
15 Volvo Drive, Rockleigh, NJ 07647
888.CRESTRON | www.crestron.com
Instructional VideosProduct Page

Other manuals for Crestron TSR-310

Related product manuals