Need help?Do you have a question about the CRT SS 6900 and is the answer not in the manual?
General| Antenna Impedance | 50 Ohms |
|---|---|
| Display | LCD |
| Power Supply | 13.8V DC |
| Antenna Connector | SO-239 |
| Modes | AM / FM |
| Frequency Control | PLL Synthesized |
| Microphone | Dynamic |
| Channels | 40 |
Observe precautions to prevent fire, personal injury, or transceiver damage.
Do not attempt to configure your transceiver while driving, as it is dangerous.
Designed for a 13.8V DC power supply; do not use a 24V battery.
Do not place in dusty, humid, wet areas, or on unstable surfaces.
Risk of burn or electric shock when connecting antenna during transmission.
Advised to move away from antenna during high power transmission.
Never allow metal objects or electrical contact to prevent shock risk.
Avoid extreme temperatures and ensure proper cooling for the device.
Check battery charge, turn off before ignition, and use correct fuse.
Turn off power immediately if abnormal odor or smoke is detected.
Connect antenna and check SWR before emitting to prevent damage.
Connect antenna and check SWR before transmitting to prevent amplifier damage.
Provides steps to restore factory default settings.
Details on choosing and installing mobile and fixed antennas.
Polarity checks, 24V considerations, and battery connections.
Warning against replacing the original fuse with a different value.
Guide to adjusting Standing Wave Ratio before first use.
Instructions for using the built-in SWR meter for antenna adjustment.
Using SWR meter display and Time-Out-Timer for transmission control.
Enabling or disabling SWR protection during transmission.
Technical details on frequency, channels, power output, and modulation.
Details on receiver sensitivity, selectivity, and audio output.
To Next Page
