Need help?Do you have a question about the Crua Hybrid and is the answer not in the manual?
Fully unroll the tent to prepare for setup.
Connect and secure the spreader bars by clicking the button.
Insert three poles into the pole sleeves, noting length differences.
Place poles in eyelets and clip them at the sides.
Position the tent, stake guy-lines at both ends, and straighten.
Instructions for pitching the tent when the flysheet is not used.
Ensure tent floor fabric is tucked underneath to avoid water pooling.
Connect the flysheet to the pole sleeves using the underside Velcro.
Buckle flysheet sides, stake down using elastic bands, and open vents.
Identify two suitably spaced trees for hanging the hammock.
Tie tree huggers around each tree using the adjustable loops.
Securely attach carabiners to loops on both sides for hammock setup.
Adjust spreader bar position to stabilize the hammock.
Align Velcro patches on pole sleeves and flysheet corners.
Use side Velcro patches to firmly secure the flysheet.
Secure guy-lines from elastic ties to the hammock ropes.
Use the provided orange ties to secure the ropes at both ends.
Open valve and inflate mattress; blow air if needed for fuller inflation.
Details on the 'Mummy-style' sleeping bag customized for the Hybrid system.
Reduce weight by removing the hanging system via knots for tent-only use.
Ensure firm and secure knots are reapplied in the exact same position when reattaching.
To Next Page
General