Crucial MX Series User Manual

How to install a Crucial
®
SSD
in your computer
If you’re a first-time installer, there’s no need to fear – the process is easy
and straightforward. It’ll take some time, but your computer will
be radically faster when you’re done!

Crucial MX Series Specifications

General

Category	SSD
MTBF	1.8 million hours
Interface	SATA 6Gb/s
Capacity	250GB, 500GB, 1TB, 2TB
Sequential Read Speed	560 MB/s
Sequential Write Speed	510 MB/s (for 1TB model)
Random Write Speed	90, 000 IOPS (for 1TB model)
Warranty	5 years
Form Factor	2.5-inch

Summary

Part 1: Prepare for SSD Installation

Gather Essential Supplies

Collect the SSD, screwdriver, computer manual, and SATA-to-USB cable for preparation.

Prepare SSD Spacer

Locate and set aside the SSD spacer; it may be needed later depending on your system.

Back Up Important Files

Save critical data to an external drive before proceeding with the installation process.

Proceed Deliberately

Read each step carefully and consult helpful tips for accurate guidance.

Part 2: Copy Data to New SSD

Connect SSD to System

Use a SATA-to-USB cable to connect the new SSD to your computer.

Download Cloning Software

Obtain the necessary data copying software from the specified Crucial website.

Install Cloning Software

Install the downloaded software by following the on-screen prompts.

Enter Software Serial Number

Input the provided 16-digit key to activate the cloning software.

Select Cloning Method

Choose 'Clone Disk' and the 'Automatic' method for data transfer.

Part 3: Install SSD into Computer

Select Source and Destination Drives

Designate your old drive as source and new SSD as destination for copying.

Shut Down System

Power off the computer and disconnect the SATA-to-USB cable.

Remove Power Cable and Battery

Disconnect the power cable and remove the laptop battery for safety.

Discharge System Electricity

Hold the power button for 5 seconds to remove residual electricity.

Open Computer Case

Consult owner's manual for specific instructions on opening the case.

Ground Yourself

Touch an unpainted metal surface to protect components from static discharge.

Locate Storage Bay

Identify the drive bay location, which varies by system model.

Remove Old Drive

Disconnect cables and unscrew the existing drive from its bay.

Attach Cables and Brackets to SSD

Connect necessary cables and brackets to the new SSD.

Reassemble System

Reconnect the battery (if applicable) and close the computer case.

Turn On Computer

Boot up the computer to confirm the SSD is installed and working.

Part 4: Optimize SSD Performance

Enable Storage Executive

Download and install Crucial Storage Executive for performance updates.

Select Download Version

Choose the correct Storage Executive version (32/64-bit) for your OS.

Run Storage Executive

Install and launch the Storage Executive software.

Enable Momentum Cache

Activate Momentum Cache for potentially 10x faster SSD performance.