CruxCare C1 - Calling the carer; Stop the notification sound; Installation; Tiiwee window & door sensor

To Next Page

To Previous Page

Calling the carer

Press the red or blue call buon; the buon will light up.

Stop the noﬁcaon sound

To stop (reset) the alarm, press any of the two buons on the pager.

Installaon

This device can be worn around the neck using a lanyard. Alternavely, mount

the call buon to a ﬁxed posion by using double-sided adhesive pads.

Tiiwee window & door sensor TWWS03

This sensor can be mounted on doors and windows. When the paent opens a

door or window, the sensor sends a wireless signal to the CruxCare C1 Pager. This

is helpful when guarding rooms or areas.

Power supply: 1 x CR2450 baery

Dimensions: 5,5 x 5,5 x 2 cm

Housing material: ABS

Radio-frequency: 433 MHz

Please ﬁnd below mounng examples for the most common situaons in your

home:

Power supply: 1 x AAA alkaline baery

Baery life: 10 - 12 months

Dimensions sensor: 78x24x18mm

Dimensions magnet: 75x10x12mm

Housing material: ABS

Radio-frequency: 433 MHZ