CSI W60 - Safety Instructions; General Warnings; User Notices

• Do not operate the device if it is visibly damaged.
• Do not block the gaps of the device.
• Do not expose the device to rain or soak it in water.
• Do not place the device near open ames or other heat sources (heaters, direct sunlight,
gas ovens etc.)
• Do not store explosive substances like spray cans with ammable propellants in the device.
• Before starng the device, ensure that the power supply line and the plug are dry.
• Check if the voltage specicaon on the type plate matches that of the energy supply.
• Once unpacked and before turning on, the device must be placed on a level surface
for more than 6 hours.
• Make sure that the device stays horizontal when it is running. The lt angle must be less
than 5° for long term running and be less than 45° for short term running.
• The refrigerator must be well venlated for heat dissipaon and have space for airow
(Back Space> 8”, Side Space> 4”).
• The device may only be repaired by qualied personnel. Improper repairs can lead to
safety hazards. If the power cable is damaged, it must be replaced by the manufacturer,
customer service or a similarly qualied person in order to prevent safety hazards.
• The device can be used by children aged 8 or over, as well as by persons with reduced
physical, sensory or mental capabilies or a lack of experience and/or knowledge,
providing they are supervised or have been taught how to use the device safely and are
aware of the resulng risks.
• Children must be supervised to ensure that they do not play with the device.
• The installaon of DC power in a boat must be handled by qualied electricians.
• Disconnect the device or switch it o when you turn o the engine. Otherwise you may
discharge the baery.