CSI W60 - Page 7

The baery protecon should be set from H to M or from M to L if there is a voltage protecon
code Fl shown on the panel. The baery gear should be set to H (high) if the refrigerator
needs to keep working aer turning o the car engine and to avoid the possibility of overuse
or draining the baery to the point where the vehicle cannot be restarted.
scenarios.
• Factory reset:
The baery protecon mode will protect your car & fridge when the voltage is insucient.
Due to the dierent output voltages between vehicles, H should be set when the product
is connected to car power, and M or L should be set when it is connected to a portable
baery or other back-up baery.
It is not recommended to change other E sengs which are used for factory maintenance.