7English
Connect the cable to the main unit and to the remote unit and then switch on the
selector switch to "S" (slow), the cable test is carried out at reduced speed. The
The measurement result is displayed simultaneously on the main unit as well as
the remote unit during the cable test. During the measurement process, the net-
the connected wire ends and whether the signal is being conducted further.
In case of a fully allocated cable with standard pin assignment and shielded con-
the corresponding LED pair does not glow.
4. Safety instrucons and liability disclaimer
Voltage higher than 60V DC or 40V AC would damage the device!
Never try to open the device to carry out repairs or conversions. Avoid contact
-
should not be used if it has received an impact or has been damaged in any other
toy. Keep it out of the reach of children or mentally impaired persons. Any repair or
warranty or guarantee. The product may only be used by persons who have read
To Next Page
Loading...