CT Systems Wavetek 2500 - Page 56

3.4.11
Miscellaneous Keyboard Programming
RF Step Size Programming
RF step size can be tailored to suit the users specific
application by using the RF STEP key as shown below.
ll Select RF STEP.
2) Enter the desired step size in MHz and press ENTER.
3) Use the up or down arrow keys to step the RF frequency.
Memory and Recall Operation
'I'wenty storage r _ egisters < l - 20) are
desired front panel keyboard settings.
memory:
l) Select STORE.
available for retaining
To store a setup in
2) Enter a memory location from l to 20 using the data keys.
3) Select ENTEH to ter:ninate.
To recall a memory register:
ll Select the RECALL key.
2) Select the desired memory register (from l to 20) using the
data keys.
3) Recall Cacti vate) the register by pressing · ENTER.
4) 1~e operator may scroll thru the stored settings by
pressing RECALL followed by the up or down arrow keys.
2500-MANUAL
PAGE
44
SECT10N-3