CTE ZED 20.3 HV - Page 5

GB
INDEX
Aerial work platform ZED 20.3 HV
5
COD. UM0284_GB | REV. 00 | ED: 09/17
5.14 Anchorage points for the harness device ______________________________________ 9
6 Procedures for Use 1
6.1 Foreword ______________________________________________________________ 1
6.2 General precautions ______________________________________________________ 1
6.3 Operating stages ________________________________________________________ 3
6.3.1 Pre-start checks .............................................................................................................................3
6.3.2 Starting the vehicle .........................................................................................................................3
6.3.3 Engaging the power take-off: .........................................................................................................4
6.3.4 Stabilising the elevating work platform (MEWP) ............................................................................4
6.3.5 Using the elevating platform ...........................................................................................................6
6.3.6 Returning the lifting platform to its rest position .............................................................................8
6.3.7 Closing the stabilisers ....................................................................................................................8
6.3.8 Switching off the vehicle .................................................................................................................8
6.4 Parking ________________________________________________________________ 9
7 Emergency manoeuvres 1
7.1 Foreword ______________________________________________________________ 1
7.1.1 Using solenoid valves ....................................................................................................................1
7.2 Work platform emergency stop ______________________________________________ 2
7.3 Levelling the work platform _________________________________________________ 2
7.4 Lowering the work platform using the ground controls in the event of operator incapacity. 3
7.5 Lowering the work platform in the event of a power cut ___________________________ 4
7.6 Manual lowering of platform from the ground ___________________________________ 4
8 Maintenance 1
8.1 Inspection logbook _______________________________________________________ 2
8.2 General Rules ___________________________________________________________ 2
8.3 Maintenance summary table _______________________________________________ 3
8.3.1 Pre-start checks .............................................................................................................................3
8.3.2 Every 50 hours of operation ........................................................................................................... 3
8.3.3 Every 100 hours of operation ......................................................................................................... 4
8.3.4 Every 6 months or 500 hours of operation ..................................................................................... 4
8.3.5 Yearly or every 100 hours of operation ..........................................................................................5
8.4 Maintenance of mechanical components ______________________________________ 6
8.4.1 Main mechanisms ..........................................................................................................................6
8.4.2 Combustion engine ........................................................................................................................6
8.5 Lubrication and greasing __________________________________________________ 7
8.5.1 Greasing the pins ........................................................................................................................... 7
8.5.2 Lubricating the stabilisers ...............................................................................................................7
8.5.3 Lubricating the telescopic boom elements ..................................................................................... 7
8.5.4 Lubricating the turntable .................................................................................................................8
8.6 Hydraulic system maintenance ______________________________________________ 9
8.6.1 Hydraulic cylinders ......................................................................................................................... 9
8.6.2 Hydraulic system pipes ..................................................................................................................9
8.6.3 Pressure check and valve adjustment ...........................................................................................9
8.6.4 Hydraulic motors and pumps .........................................................................................................9