7
2-2 PTO Mount Plate Assembly
Installation
Secure the PTO mount plate assembly P#(A1108) to the
chassis of the mower using (4) 3/8”-16 x 1-14” carriage
bolts P#(K1183) and (4) 3/8-16 nylon flange locknuts
P#(K2038). Leave the hardware loose until the lower
mount assembly is installed in the next section. Refer to
Figure 2-2.
2-3 Lower Mount Assembly
Installation
Secure the lower mount assembly P#(A1110) to the rear
frame of the mower using (4) 3/8”-16 x 1-1/4” carriage
bolts P#(K1183) and (4) 3/8”-16 nylon flange locknuts
P#(K2038). Leave the hardware loose. Secure the lower
mount assembly to the PTO mount plate assembly using
(2) 3/8”-16 x 1-1/4” carriage bolts P#(K1183) and (2)
3/8”-16 nylon flange locknuts P#(K2038). Tighten all
hardware from Sections 2-2 and 2-3 at this time. Refer to
Figure 2-3.
Figure 2-3
Carriage
Bolt
Carriage
Bolt
Nylon Flange
Locknut
Figure 2-2
PTO Mount
Plate Assembly
Carriage
Bolt
Lower Mount
Assembly
PTO Mount
Plate Assembly
Nylon Flange
Locknut
To Next Page
Loading...
