Engine
4‐17
Inspect the engine cooling fan:
Engine cooling fan
Air shroud 1
Air shroud 2
Look for cracks or damage, if
necessary replace.
3.
Install:
Woodruff key
A.C. magneto
Engine cooling fan (1)
Install the bolts in the holes in the
collar of the engine cooling fan.
7 Nm or 5 ft lbs
Note:
When installing the A.C. Magneto
cover,
use a long rod to hold the A.C.
Magneto
rotor in position from the
outside. This
will make assembly
easier. Be careful
not to damage the oil
seal. Apply
Note:
Install the air shroud (1).
10 Nm or 7 ft lbs
sealant (1) to the bolt threads (2)
shown
in this illustration.
Before installing the engine cooling
fan pulley, do not forget to install
the O-ring.
Install engine cooling fan pulley (1).
55 Nm or 40 ft lbs
Install the engine cooling fan air duct
assembly with the arrow mark (a)
towards the air shroud (1).
To Next Page
Loading...
