Document: - page 13 (Black)
Screen angle and frequency: 45.0000, 150.0000
13
MAINTENANCE
CLEANING DEBRIS
CAUTION: Do not use water to clean engine parts.
Water could contaminate fuel system. Use a brush
or dry cloth.
Engine parts should be kept
clean to reduce the risk of
overheating and ignition of
accumulated debris. This is
especially important if cutting
tall grass. Daily or before every use, clean accumulated
debris from engine.
WARNING
Keep linkage, springs and controls clean.
Keep area around and behind muffler free of any combus-
tible debris.
Keep muffler area clean and muffler in working order. Daily
or more often, before running engine, clean muffler area to
remove all grass and combustible debris. If engine muffler
is equipped with spark arrester screen, remove for cleaning
and inspection. Replace if damaged or plugged.
Rotating Screen
ROTATING SCREEN
Linkage, Springs and Controls
CLEAN
ADJUSTMENTS
CONTROL ADJUSTMENTS
WARNING
Prevent unintentional starting.
Before performing adjustments:
• Remove spark plug wires from spark plugs.
• Disconnect battery at negative terminal (only
engines with electric start).
TO ADJUST REMOTE CHOKE CONTROL
CASING CLAMP SCREW
PULL TO CHOKE
WIRE AND
CASING
[1] Remove air cleaner.
[2] Move choke control to CHOKE or START position.
(Carburetor choke should be completely closed.)
[3] If not, loosen casing clamp screw.
[4] Then move casing, wire and engine choke lever in
direction shown until choke is completely closed.
[5] Tighten casing clamp screw. Replace air cleaner.
To Next Page
Loading...
Need help?
General