RZT-S
52
To replace the front wheel bearings:
1. Lift and safely support the front of the mower.
2. Remove the front wheel by following the procedures
describe in the previous section of this chapter.
3. Drive the bearings out of the wheel hub using a drift
or pin punch. See Figure 5.11.
4. Drive in the new bearings using a brass punch or a
tube that has the same O.D. as the bearing.
See Figure 5.12.
5. Install the front wheel.
6. Pump grease in the grease fitting on the front wheel
until it starts to squirt out of the hub.
7. Test drive the mower before returning it to service.
Figure 5.11
Punch
Figure 5.12
Brass punch
www.mymowerparts.com
For Discount Cub Cadet Parts Call 606-678-9623 or 606-561-4983
To Next Page
Loading...
