14 Section 2— ASSembly & Set-Up
Installing the Seat
1. Remove the two flange lock nuts and shoulder bolts from
the manual bag. See Figure 2-9.
Figure 2-9
2. Place the seat into position and secure the seat into place with
the hardware as shown in Figure 2-9.
3. Remove the shoulder screw and flange lock nut from
manual bag and install the seat lockout bracket as shown in
Figure 2-10.
Figure 2-10
4. Insert the wiring harness into the bottom of the seat as
shown in Figure 2-11.
Figure 2-11
NOTE: When the harness is connected, be sure to push the
excess wire from the wire harness into the seat box hole
before continuing.
Seat Adjustment
This machine is equipped with an adjustable seat, which includes
a retractable seat belt assembly and an Operator Presence Sensor
(OPS). The OPS in the form of a switch, is integrated into the seat
bottom and is connected to the machine electrical system.
The seat can be adjusted forward and backward, the armrests
can be adjusted up and down, the mechanical suspension
mechanism weight/ride adjustment controls can be adjusted for
weights between 125- and 275-pounds, a lumbar support can be
adjusted and the seat can tilt forward and backward.
To move the seat forward or back, locate the seat adjustment rod
under the seat. Push the rod to the left and slide the seat forward
or back into the desired position and release the rod when the
seat is in the desired position. See Figure 2-12.
Figure 2-12
To Next Page
Loading...
