Warning
Warning
Provide at least 20cm of space between the product and
the wall.
- Being too close to the wall may cause product failure.
For cleaning or servicing, unplug the power cord, close the feed
water valve, and wait until the product comes to a complete stop.
- Otherwise, electric shock or physical injury may result.
Remove the dust on the Condenser, which is on the front or side
of the product,
at least once a month.
- Heavy dust on the Condenser prevents heat dissipation
and deteriorates the product performance, leading to excessive
power consumption and/or product failure.
The ambient temperature range must be between 10℃ to 38℃
- installation in a cold place 0℃ or below, freeze break may occur.
- Installation in a hot place 38℃ or over, product failure may occur.
The pressure and temperature of the supply water must be
1kgf/㎠~5kgf/㎠, and 10℃~32℃, respectively.
- If the pressure or temperature of the supply water exceeds
the above specified ranges, the ice quality may be deteriorated
and/or product failure may occur.
Make sure to connect the product with a cold water line.
- Connection to a hot water line may cause product failure.
The supply water must be from the city service water.
To Next Page