36
CChheecckk bbeeffoorree aasskkiinngg ffoorr sseerrvviiccee
Did you put a plug in the socket?
Air flow and
Spray isn’t
made?
Warm humidi-
fication isn’t
made
When too low
spray volume
is made
Air flow is made
but Spray isn’t
made
Put a plug in the socket.
Isn’t “REFILL” alarm lamp dis-
played as red color?
Isn’t too much water in water tank?
Remove water in water tank, fasten water
tank cover, and put it again.
Make desired humidity higher than pre-
sent humidity.(Only when desired humidi-
ty is higher than present humidity, spray
can be made.)
Isn’t desired humidity is the same
as present humidity or fixed very
low?
Did you find oil component of soap
or cosmetic at the time of clean-
ing?
Wash water tank, spray room and spray
outlet again with clean water.
Did long time pass after you oper-
ated product?
It takes a little while to boil the
water warm. After about 10 min-
utes, warm humidification is
made.
Isn’t water temperature very low? Because, if water temperature can
be low, fix spray volume as maxi-
mum and operate it for about 10
minutes.
Isn’t the surface of oscillator water
stained?
Clean oscillator and water tank
section.
Put water into water tank.
Case
Check points
Do the following
REFILL
POWER/REFILL
(LH-5311N) (LH-5311FN)
To Next Page
Loading...