Cuddeback Attack IR - Installing Batteries and SD Card

5
Step 2 – Installing Batteries and SD Card
 1) TurntherotaryknobtotheOFF position.
 2) Loosenthebatterythumbscrewandopenthe
battery compartment door. Install four brand new
alkaline D cell batteries. Make sure to observe
correct polarity. Close the door and tighten the
thumb screw completely.
 3)
Aseriesofnumbersaredisplayed.TheseareAttack’s
hardware and software version numbers.
 4) WaituntiltheLCDdisplaygoesblankandthe
  greenandredLEDsareoff.
 5) InstallyourSDcard.Besuretoobservethecorrect
polarity with clipped corner on the card to the right.
Bottom View
Battery Install SD Card Install