3
2. Enable the CL LEVEL menu and wait for a signal level
to appear (- - means no signal, and a number
indicates a signal. If you do not get a signal within 3
or 4 minutes or signal is less than 15 you must move
closer to the HOME camera or closest Remote
camera.)
3. Set the camera sengs (date, me, delays, etc.)
4. Deploy and ARM the REMOTE camera
5. Repeat these 4 steps for all your REMOTE cameras
STEP 5. Deploy addional REMOTE CAMERAS
1. Repeat Step 4 for all your REMOTE cameras
STEP 6. Read this manual
1. Read this manual for full details on performing the
above steps, and for detailed instrucons.
To Next Page
Loading...
