Enjoy the internet!
Quick Installation Guide
NEED TECH HELP?
810600331
www.cudy.com/qr_vg_ap
www.cudy.com
support@cudy.com
www.cudy.com/download
Power Supply1
PoE Switch
AP
Method 2: PoE Switch
Connect an Ethernet cable from the PoE switch to the Ethernet port.
Method 1: DC Adapter
Plug one end of the provided power adapter into the DC POWER
port of the AP and the other end to a standard electrical wall outlet.
AP
Power Adapter
Software Configuration
2
Method 1: Standalone Mode
To configure and manage APs separately.
Choose from the following methods to configure your APs.
Clients
Router AP
Internet
LANWAN
Note 1：
1. Before you start, be sure to power up and connect your devices according to the
topology figure.
2. A DHCP server (typically a router with DHCP function enabled) is required to assign IP
addresses to the APs and clients in your local network.
Note 2：
If the router you use is a Cudy mesh WiFi router(firmware version:1.15.28 or later), then
the access point will auto work as an add-on mesh unit and share the same WiFi network
name and password with the Cudy router you connect.
1. Connect wirelessly by using the default SSID printed on the
bottom label of the product.
2. Launch a web browser and enter http://cudyap.net/ in the
address bar. Create a password to log in.
http://cudyap.net/
Confirm
3. Click "Quick Setup", the window below will pop up, please
follow the step-by-step instructions to set up the internet
connection.
Quick Setup
Mode Timezone Connections Wireless Summary
Exit
Next
Wireless Router
Opertion Mode
Wireless Access Point
Wireless Extender
WISP
4
5
3
2
1
Method 3: PoE Adapter
Connect an Ethernet cable from the Ethernet port of the AP device
to the PoE port of the provided PoE adapter.
LED and Button
PoE Adapter
AP
LAN
PoE LAN
Off
Red
Blue
Flashing blue
Yellow
Flashing yellow
Red, blue, and yellow alternate
Red and blue alternate
LED
Reset Button
To Next Page
Need help?
General
