5
leakage, and significant decrease in capacity, stop using it
immediately and handle it properly.
•Do not charge or discharge this product in any places that may
affect its heat dissipation, such as pockets, enclosed bags, on the
beds, sofas, and other places. Confirm that this product is not
covered by clothing, pillows, bedding, or other debris during use.
When the devices such as mobile phones are to be charged for a
long time, do not stack this product together with other devices
such as mobile phones, so as to ensure ideal heat dissipation for
them.
•Do not disassemble, squeeze, puncture, short-circuit this
product, or put it into water, fire (including near stoves, heating
installations, and other heat sources), or expose this product to
an environment with a temperature higher than 60 ℃ (140 ° F).
•In hot weather, keep this product away from an unmanned vehicle
outdoors or other places exposed to sunlight.
•To avoid battery damage or other hazards, do not disassemble
the product shell without permission because this product
contains a lithium ion polymer battery.
•When powered by Type-C1 and the power exceeds 100W, the
enclosure of the terminal device needs to comply with the fire
protection requirements of IEC 62368-1.
•Please fully charge this product before its first use.
•To charge this product or use this product to charge other
devices, please choose an appropriate charger and data cable
(CUKTECH charger and data cable are recommended).
•This product should be charged in an attended manner. Cut off
the power supply when you are going out or leaving for a long
time.
•As long as this product is fully charged or has fully charged
other devices, timely unplug the connection cable to avoid loss in a
long-time connection state.
•If the product has no power indication after a button is pressed,
it may be in a protected state. You can connect to an external
charger to recover it.
Precautions
Tips: The illustrations about the product, accessories, and
user ports in the Manual are schematic diagrams for
reference only. Due to product updates and upgrades, there
may be slight differences between the physical product and
the schematic diagram, and the physical product shall
prevail.
To Next Page
