1)
Valid for versions with the start button on the centre console.
If no valid key is detected inside the vehicle,
an emergency start-up will be required. The
relevant message will appear in the dash panel
display. This may happen when, for example,
the vehicle key battery is very low.
●
Immediately after pushing the starter button,
keep the key next to the right trim of the steer-
ing column ›››Fig.90, as close as possible to
the Kessy logo.
●
The ignition connects and the engine starts
automatically.
Indications for the driver on the in-
strument cluster screen
Press the brake
●
This message appears on vehicles with an
automatic gearbox if the driver tries to start
the engine without having the brake pedal
pressed.
Select N or P
●
This message appears if you try to start or
stop the engine when the selector lever of the
automatic gearbox is not in position P or N.
The engine can only be started and stopped in
those positions.
Engage position P; the vehicle can
move; doors can only be locked in
position P.
●
For safety reasons, this driver message ap-
pears and an audible warning sounds if the
selector lever of the automatic gearbox is not
in position P after you switch o the ignition.
Move the selector lever to the P position, oth-
erwise the vehicle could move.
Gear change: Selector lever in the
drive position!
●
This driver message is displayed when the
selector lever is not in the position P when the
driver door is opened. Additionally, a buzzing
sound is emitted. Put the selector lever in posi-
tion P, otherwise the vehicle could roll away.
Ignition is switched on
●
This driver message is displayed and a buz-
zer is sounded when the driver door is opened
with the ignition switched on.
Start-Stop system
Description and operation
The Start-Stop system helps you to save fuel
and reduce CO
2
emissions.
In Start-Stop mode, the engine will automati-
cally switch o when the vehicle stops or is
stopping. The ignition remains switched on.
The engine automatically switches back on
when required.
In this scenario, the light of the
button remains lit.
1)
When the ignition is switched on, the Start-
Stop function is automatically activated.
Control lamps
The Start-Stop system is available, the
automatic engine shutdown is active.
The Start-Stop system is not available or
has been disconnected.
Stopping and starting the engine
Vehicles with an automatic gearbox:
●
Brake until the vehicle has come to a stand-
still, and keep your foot on the brake pedal or
activate the Auto Hold system so that the vehi-
cle remains braked. The engine will stop. The
warning lamp will appear on the display. The
engine can be stopped before stopping com-
pletely (approximately 7 or 2 km/h depending
on the vehicle's gearbox).
●
When you take your foot o the brake pedal
the engine will start up again. The indicator
lamp goes out. With the Auto Hold system, the
To Next Page
Loading...
