Cupra ATECA 2022 - Page 154

152
Assistant systems
1
2
WARNING
The ACC’s technology cannot overcome the
system's inherent limitations or change the
laws of physics. If used negligently or invol-
untarily, it may cause serious accidents and
injuries. The system is not a replacement for
driver awareness.
●
Always be prepared to brake or accelerate.
●
If you press the accelerator pedal the ACC
will stop working. Therefore, it will not brake
or request any braking intervention.
●
Adapt your speed and safe distance to the
vehicle in front of you at all times to suit visi-
bility, weather, road and traic conditions.
●
Do not use the ACC in poor visibility, or on
roads that are steep, with lots of curves or
slippery.
●
Never use ACC when driving o-road or on
unpaved roads.
●
The system does not react in time to
stationary obstacles (such as a traic jam
queue). React soon enough to avoid a haz-
ardous situation.
●
The system does not react to people, an-
imals or vehicles that are crossing or ap-
proaching in the opposite direction.
●
If you are driving with a spare wheel tted,
the ACC system could automatically switch
o. Switch o the system when starting o.
●
Brake immediately if the ACC does not slow
down enough.
●
Brake immediately when a driver interven-
tion instruction is displayed on the instru-
ment cluster screen.
●
If the vehicle continues to move involun-
tarily after a driver intervention prompt,
brake the vehicle.
Note
If the ACC does not work as described in
this chapter, do not use it until it has been
checked by a specialised workshop. CUPRA
recommends visiting a specialised CUPRA
dealer or any SEAT dealership.
ACC operation
Fig.109 On the instrument panel display:
ACC active.
Fig.110 On the multifunction steering
wheel: buttons for operating the ACC.
›››Fig.109
Vehicle ahead detected. It will light up if
the distance to the vehicle is adjusted.
Selected distance level 2.
This information can be displayed on the cen-
tral panel of the Assistants view, or in the left
hand information prole ›››page14. If these
views are not selected, it will be automatically
displayed in the lower central part of the in-
strument cluster in a simplied manner.
The set speed will be displayed next to the
function status indicator.
Connecting
●
Press the button on the multifunction
steering wheel ›››Fig.110.
The ACC does not regulate anything yet
(standby).