EasyManua.ls Logo

Cupra ATECA 2022 - Page 178

Cupra ATECA 2022
357 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
176
Parking and manoeuvring
Pay attention and do not rely solely on park
assist systems.
Always be prepared to brake and control
the steering yourself.
Do not take any risks that compromise
safety.
Act in accordance with the warnings and
driving recommendations of the parking sys-
tems.
Note
Switch o the parking system if the auto-
matic brakes operate excessively, e.g. when
driving o-road.
After the park assist’s manoeuvre braking
function has braked the vehicle, driving in
the same direction for 5 metres is deactiva-
ted, and becomes active again after changing
gear or changing the position of the gear se-
lector.
Troubleshooting
The parking system behaves dierently than
expected
There can be several causes:
The system requirements are not met.
The sensors or the camera are dirty or have
ice on them ›››page322.
The camera lens is not clean and the camera
image is not clear ›››page322.
Some noise sources, such as a jackhammer
or a cobblestone surface can interfere with the
ultrasound signal.
The vehicle has some type of damage in the
sensor or camera area, e.g. due to a parking
impact.
The sensor detection zone or eld of view of
the camera are blocked by an accessory, e.g. a
bike rack.
Changes have been made to the paintwork
or structural modications in the sensor or
camera area, e.g. at the front of the vehicle or
to the running gear.
Also take into account the messages displayed
on the infotainment system screen.
Sensor or camera without visibility, or the
parking system has been switched o
If a sensor fails, that sensor zone is perma-
nently switched o. The aected sensor zone
may be displayed on the infotainment system
with a symbol and a greyed-out graphic
segment. If necessary, the parking system
switches o the aected zone.
If the park assist is not working properly, a con-
tinuous audio signal sounds for a few seconds
when it is switched on. If applicable, a message
to this eect is displayed on the instrument
cluster screen
Check if one of the causes indicated above
has occurred.
Once the source of the problem has been
eliminated, the system may be reconnected.
If the problem persists, consult a specialised
workshop.
Parking aid Plus
Description
Fig.126 Parking aid view on the
Infotainment system display.
Parking aid plus
assists the driver by giving
visual and audio warnings about obstacles de-
tected in front of and behind the vehicle.
The bumpers are tted with sensors. When
an obstacle is detected, it is indicated by au-
dible signals and in the Infotainment system
›››Fig.126.

Related product manuals