Cupra ATECA 2022 - Page 182

180
Parking and manoeuvring
Visual indication segments
Fig.129 Parking aid view on the
Infotainment system display.
The optical indication of the segments works
as follows:
●
White segments: the obstacle is more than
approx. 30 cm away from the path or in the
direction opposite to travel. They are also dis-
played when the electronic parking brake is ac-
tivated.
●
Yellow segments: the obstacles lie on the
vehicle’s path and are at a distance of less than
approx. 30 cm away.
●
Red segments: obstacles are less than ap-
prox. 30 cm away.
A guiding track will indicate the anticipated for-
ward or backward trajectory, depending on the
gear that is engaged.
If an obstacle is located in the vehicle’s way,
the corresponding audible warning will sound.
When the penultimate segment is displayed,
the vehicle has reached the collision zone. In
the collision zone, the obstacles are represen-
ted in red (including those out of the path).
Stop the vehicle! ››› in Description on
page178
In the event the car is equipped with the Top
View Camera system, Park Assist visual guid-
ance will appear in accordance with the view
selected in the Top View Camera system.
Rear parking aid
Description
The rear park assist is an optical and audible
assistant that warns of obstacles located be-
hind the vehicle.
There are sensors integrated in the rear
bumper. When they detect an obstacle, you
are alerted by audible and visible warnings on
the Infotainment system.
If the Top View Camera system is installed, the
rear parking aid will issue an audible warning
about objects near the rear of the vehicle, and
the Top View Camera image will be available on
the infotainment screen, giving a real image of
the objects around the car.
Make particularly sure that the sensors are not
covered by adhesives, residues, dirt and the
like, as this could aect the system's operation.
Cleaning instructions ›››page322.
The approximate measurement range of the
rear sensors is:
●
Side area: 0.60 m
●
Central area: 1.60 m
As you approach the obstacle, the frequency
of the audible signals will increase. The signal
will sound continuously at around 0.30 m: Stop
the vehicle! ›››
on page178.
If the separation is maintained, the warning
volume is reduced after about 4 seconds.
Parking Aid connection
●
Select reverse gear.
Parking Aid disconnection
●
Drive forward at 15 km/h (9mph) or faster.
●
OR: place the selector level in position P, N
or D (for automatic gearboxes) or disengage
reverse (for manual gearboxes).
Set the lever to the N or D position to maintain
the system active for approximately 8 seconds
before switching o. During this time, the Park-
ing aid will be deactivated if the selector lever is
set to P.