Cupra ATECA 2022 - Page 21

Driver information
19
Instrument panel
–
–
–
–
–
–
–
–
Select the instructions
In the Infotainment system, in the menu Ve-
hicle settings, you can display dierent travel
data ›››page32.
Current consumption: The current
fuel consumption display operates
throughout the journey, in litres/100 km;
and with the engine running and the vehi-
cle stopped, in litres/hour.
Average consumption: The average
fuel consumption is displayed after driving
for approximately 300metres.
Travelling time: This indicates the
hours (h) and minutes (min) since the igni-
tion was switched on.
Range: Approximate distance in km that
can still be travelled if the same driving
style is maintained.
Distance travelled: Distance covered
in km (m) after switching on the ignition.
Average speed: The average speed will
be shown after driving for approximately
100metres.
Digital speed: Current speed dis-
played in digital format.
Eco tips: Recommendations messages
are shown to reduce consumption through
good driving practices, e.g. Air condi-
tioning on: close the window.
Setting a speed warning
●
Select the display Warning at ---km/h or
Warning at ---mph.
●
Press the button on the multi-function
steering wheel to memorise the current speed
and activate the warning.
●
Activate: set the desired speed within 5 sec-
onds by rotating the wheel on the multi-func-
tion steering wheel. Next, press the button
again or wait for a few seconds. The speed is
stored and the warning activated.
●
Deactivate: press the button. The stored
speed is deleted. The warning can be set for
speeds of between 30 and 250km/h (18 and
155mph).
Oil temperature display
The engine reaches its operating temperature
when, under normal driving conditions, the
oil temperature is between 80°C (176°F) and
120°C (248°F). If a great eort is required from
the engine and the outside temperature is
high, the engine oil temperature may increase.
This does not present any problem as long as
the warning lamps
or ›››page296 do
not appear on the display.
Warning and information messages
The system runs a check on certain com-
ponents and functions when the ignition is
switched on and while the vehicle is moving.
Faults are displayed on the instrument clus-
ter display as red and yellow warning symbols
›››page11 accompanied by messages and,
depending on the case, even an audible warn-
ing. The representation of the messages and
symbols may vary depending on the version of
the instrument panel.
Existing faults can also be checked man-
ually. To do this, open the Vehicle status
›››page26 menu.
Priority 1 warning (in red)
The symbol lights up or ashes (in part ac-
companied by audible warnings). Stop driv-
ing! Danger! Check the fault and eliminate
the cause. If necessary, seek professional as-
sistance.
Priority 2 warning (in yellow)
The symbol lights up or ashes (in part accom-
panied by audible warnings). Operating faults
or the lack of operating uids can cause dam-
age to the vehicle or a fault. Check the faulty
function as soon as possible. If necessary, seek
professional assistance.
Reference to information in the own-
er's manual
Further information on any warnings can be
found in the owner's manual.