Cupra ATECA 2022 - Page 61

Safety
59
Transporting children safely
Weight group
Front passenger seat
a)
Rear side seat Rear central seat
b)
Airbag enabled Airbag deactivated
c)
Group 0 to 10 kg X U U U
Group 0+ to 13 kg X U U U
Group I 9 to 18 kg X U U U
Group II 15 to 25 kg X UF UF UF
Group III 22 to 36 kg X UF UF UF
X: Not compatible for the installation of seats install chairs in this conguration.
U: Suitable for universal restraint systems for use in this weight group.
UF: Acceptable for front-facing universal-category child restraint systems approved for this mass group.
a)
Compliance with current national legislation and the manufacturer's instructions is required when using or installing child seats.
b)
For semi-universal chairs where the securing system is the car safety belt and the support bracket, do not use them in the centre rear seat.
c)
Seats without height adjustment should be placed in their rearmost position. Seats with height adjustment should be placed in their rearmost and highest
position.
Fitting a child seat using the seat belt
●
Set the height of the seat belt such that
it adapts to the child seat naturally, without
twisting. The lowest position of the seat belt
height regulator must be used with rear-facing
child seats.
●
Put the seat belt in place and pass it through
the child seat according to the instructions of
the child seat manufacturer.
●
Make sure that the seat belt is not twisted.
●
Insert the latch plate into the seat's buckle
until you hear the engagement click.
WARNING
When travelling, children must be secured in
the vehicle with a restraint system suitable
for age, weight and size.
●
Always read and observe information and
warnings concerning the use of child seats
›››page52.