Cupra ATECA 2022 - Page 69

Opening and closing
67
Keyless Access system
B
Locking sensor surface on the outside of
the door handle.
Depending on the equipment, the vehicle may
have the Keyless Access system. This is a key-
less locking and starting system that can un-
lock and lock the vehicle without actively using
its key. For this, it is only necessary that there
is a valid vehicle key in the detection area cor-
responding to the attempted access to the ve-
hicle.
Conguring the Keyless Access system
The behaviour of the Keyless Access system
can be adjusted in the Vehicle settings menu
of the Infotainment system ›››page32.
If the Keyless Access function is disabled, its
operation is limited.
Unlock the vehicle
●
Touch the sensor surface on the inside of the
handle
A
. All turn signals ash twice.
If selective opening is tted, touching the sen-
sor's surface twice unlocks the entire vehicle.
If the vehicle is not unlocked for an extended
period, the function is deactivated. The func-
tion will reactivate the next time that the vehi-
cle is unlocked with the remote control.
Lock the vehicle
●
Park the vehicle.
●
Touch the sensor surface ›››Fig.47
B
on
the outside of the door handle. All turn signals
ash once.
To check that the vehicle is properly locked,
the unlocking function is deactivated for a few
seconds.
Unlocking the rear lid
When the vehicle is locked, the rear lid auto-
matically unlocks when it is opened if there is
a vehicle key in its proximity zone. The rear lid
locks again after closing.
Temporarily deactivating the Keyless Access
system
The “Keyless Access” system’s unlocking func-
tion can be temporarily deactivated:
●
Move the gear lever to position P since oth-
erwise the vehicle cannot be locked.
●
Lock the vehicle using the button on the
vehicle key.
●
Within 5 seconds, touch the sensor on the
outside of the door handle ›››Fig.47
B
once. Do not grip the handle while doing so.
This temporarily deactivates the Keyless Ac-
cess system.
●
Check that it is deactivated by pulling the
door handle after at least 10 seconds. It should
not be possible to open the door.
The next time, the vehicle can only be un-
locked electronically with the vehicle key. After
being unlocked the next time, the Keyless Ac-
cess system will be activated again ››› .
Permanently disabling the Keyless Access
system
The Keyless Access system can also be perma-
nently deactivated in the infotainment system
›››
.
Convenience functions
To close all the electric windows and the sun-
roof using the comfort function, keep a nger
for a few seconds on the locking sensor sur-
face ›››Fig.47
B
of the door handle until the
windows and roof have closed.
How the doors open when touching the sen-
sor surface on the door handle will depend on
the settings that have been activated in the
infotainment system, using the function but-
ton > Settings > Opening and clos-
ing.
NOTICE
Deactivating the Keyless Access system also
deactivates the sensor controlled opening
and closing of the rear lid, although the func-
tion is shown as “active” in the vehicle menu.