Cupra BORN 2022 - Page 118

116
Lights
Note
●
When you turn the ignition o without hav-
ing turned the turn signals o, an acoustic
signal sounds while the driver door is open.
This is intended as a reminder to switch o
the turn signal, unless you wish to leave the
parking light on.
●
If the convenience turn signals are oper-
ating (three ashes) and the other conven-
ience turn signals are switched on, the active
part stops ashing and only ashes once in
the new part selected.
●
The turn signal only works when the igni-
tion is switched on. The hazard warning lights
also work when the ignition is switched o.
●
The main beam headlights can only be
switched on if the dipped beam headlights
are already on.
●
In cold or damp weather conditions, the
headlights, tail lights and turn signals may
mist up inside temporarily. This is normal and
in no way eects the useful life of the vehicle
lighting system.
●
The parking light does not activate auto-
matically if the left- or right-hand turn signal
is left on and the ignition is disconnected.
Main beam assist (Light Assist)
The main beam assist automatically prevents
glare from vehicles moving in the opposite di-
rection or ahead in the same direction. In addi-
tion, the main beam assist detects illuminated
areas and disconnects the main beam head-
light when passing, e.g. by populated areas.
Within its limitations, the assist system auto-
matically connects or disconnects the main
beam headlight depending on the environ-
mental and traic conditions, as well as the
speed ››› .
Switching on the main beam assist
●
Switch on the ignition and select mode
on the headlight control ›››Fig.103.
●
From the base position, press the turn sig-
nal and main beam headlights lever forwards
›››Fig.104
3
.
When the main beam assist is switched on,
the control lamp on the instrument cluster
screen turns on. When the main beam is on,
the blue main beam control lamp on the
instrument cluster switches on.
Switching the main beam assist o
●
Switching o mode on the headlight
control ›››Fig.103.
●
EITHER: if main beam assist is on, pull the
turn signal light and main beam headlights
lever back ›››Fig.104
4
.
●
OR: if the main beam assistant is on, but the
main beam does not turn on, press the turn
signal and main beam lever forwards to turn
the main beam on manually. Pull the turn sig-
nal and main beam lever back to switch o the
main beam manually, if necessary.
●
OR: switch o the ignition.
System limitations
In the following cases, the main beam head-
light must be switched o manually because
the main beam assist will not disconnect it on
time or disconnect it at all:
●
On roads with insuicient lighting with very
reective signs
●
If road users are insuiciently lit up, e.g. pe-
destrians or cyclists.
●
On closed curves, when the traic in the
opposite direction is partially hidden, on pro-
nounced slopes or inclinations.
●
On roads with traic in the opposite direction
and with a central reservation barrier where
the driver can see over it e.g. lorry drivers.
●
In the event of fog, snow or heavy rain
●
In the event of dust or sand storms
●
If the windscreen is damaged in the camera's
eld of vision.
●
If the camera's eld of vision is misted up,
dirty or covered by a sticker, snow or ice.
●
If the camera is damaged or if the power
supply has been cut o.