Cupra BORN 2022 - Connecting and Disconnecting the Drive Sys- Tem

Driving
143
Connecting and disconnecting the drive system
The vehicle is going to stall in traic shortly!
The vehicle can still be started twice
›››page148 and moved a short distance at
a maximum speed of 7 km/h (4 mph).
The comfort function of the air conditioning
are restricted.
●
When traic conditions permit, move to the
right hand side of the road and park the vehi-
cle safely, or drive to a charging station if possi-
ble.
When the power increases again, the control
lamp goes out.
Driving is not possible
The high voltage battery temperature is too
low
The control lamp turns on before the drive sys-
tem is switched on.
The control lamp lights up red.
A message is displayed in the Digital Cockpit.
An audio signal sounds.
If driving with very low power, the vehicle
could stall in traic!
Only manoeuvring is possible (at a speed of up
to 7 km/h [4mph]).
The comfort function of the air conditioning
are restricted.
●
When the state of charge of the high-voltage
battery is low, charge it ›››page72.
●
If you are planning to depart with low outside
temperatures, CUPRA recommends pre-heat-
ing the vehicle while it is parked ›››page136.
Doing so also heats up the high-voltage bat-
tery. This increases the power available directly
after switching on the drive system.
Please note the behaviour of the Digital Cock-
pit’s power indicator.
When the power increases again, the control
lamp goes out.
Limited power
The control lamp switches on yellow.
A message is displayed in the Digital Cockpit.
An audio signal sounds.
The power drops considerably and may be re-
duced further.
The comfort functions of the air conditioning
are restricted ›››page128.
●
When the state of charge of the high-voltage
battery is low, charge it.
When the outside temperature is very high or
low, the high voltage battery heats up or cools
down while driving. The power increases again
after a certain amount of time.
Please note the behaviour of the Digital Cock-
pit’s power indicator.
When the power increases again, the control
lamp goes out.
Connecting and discon-
necting the drive system
Switching the ignition on/o
Fig.115 Starter button
Some vehicle functions are activated when the
driver approaches the vehicle with the corre-
sponding key.
Switching on the ignition
●
Press the brake pedal.
●
OR: press the ignition/start button once. The
ignition/start button is located on the right
hand side of the steering column.