Cupra BORN 2022 - Driving Assist (Travel Assist)

176
Assistant systems
Driver intervention prompt
If the steering is not corrected manually, the
system prompts the driver through an indi-
cation on the instrument panel display and
acoustic warnings.
If no reaction is obtained from the driver, the
system switches to a passive state.
Depending on the equipment, Emergency As-
sist activates if it is turned on in the infotain-
ment system.
Regardless of the steering manoeuvres,
through an indication on the instrument panel
display and acoustic warnings, the driver is also
prompted to drive through the centre of the
lane if the steering correction lasts more than
reasonable.
Steering wheel vibration
The following situations may result in a steering
wheel vibration:
●
The lane ceases to be recognised during a
sudden intervention in the direction of the sys-
tem.
It is also possible to select steering wheel vibra-
tion in the Vehicle menu of the infotainment
system. In this case, when a vehicle with Lane
Assist switched on crosses over a detected lane
marking, the steering wheel will vibrate.
Note
If the lane departure warning assistant is
faulty, it may switch o automatically.
Troubleshooting
Lane Assist is not available
The control lamp switches on yellow. A rele-
vant warning is also displayed on the instru-
ment panel screen.
●
The eld of vision of the camera is dirty.
Clean the windscreen ›››page314.
●
The visibility of the camera is diminished due
to accessories or adhesives.
●
There is a fault or a defect. Turn the drive
system o and on again.
The system behaves dierently than expec-
ted
●
The camera has been altered or damaged,
e.g. because of damage caused to the wind-
screen. Check for visible damage.
●
Do not mount objects on the steering wheel.
If the problem persists, consult a specialised
workshop.
Note
After switching on the ignition, it may take a
few seconds before a fault is detected in the
system.
Note
If Lane Assist is unavailable, Emergency Assist
and Travel Assist will be unavailable as well.
Driving Assist (Travel As-
sist)
Introduction
Travel Assist combines adaptive cruise control
(ACC) and the adaptive lane guidance func-
tion. Within the limitations of the system, the
vehicle can maintain a distance from the vehi-
cle in front that is preselected by the driver
and remain in the preferred position within the
lane.
Travel Assist uses the same sensors as Adaptive
Cruise Control (ACC) and Lane Assist. There-
fore, carefully read the information about
the ACC ›››page163 and the Lane Assist
›››page174 and take into account the limita-
tions of the systems and the indications given
in the information.