Cupra BORN 2022 - Page 182

180
Assistant systems
1. Access the assistant menu.
2. Select Travel Assist.
3. Activate or deactivate lane change assist as
a sub-function of Travel Assist.
Note
●
If a fault occurs in the system, the lane
change assist may automatically switch o or
be interrupted during the lane change.
●
If Side Assist is not available, lane change
assist is not available either.
Activating lane change assist while driving
1. Press the button.
Lane change assist is activated. The arrows
of your own lane on the instrument cluster
display are grey ›››Fig.136
2
Changing lanes
If the system detects no objects in the detec-
tion eld of the sensor system and an assisted
lane change to an adjacent lane is possible, the
corresponding lane is shown in the instrument
cluster display next to the driver’s own lane.
The arrow on the corresponding side of the
lane is displayed in white ›››Fig.136
2
.
1. When the convenience turn signal is ac-
tivated on the desired side, the vehicle
changes lane. A message is also displayed.
When changing lanes, the vehicle automati-
cally activates the turn signal on the corre-
sponding side. Once the lane change is com-
plete, the turn signal automatically switches
o.
WARNING
The sensor system cannot reliably detect all
objects in the surroundings and operates ex-
clusively within the limits of the system. If you
use the lane change assist irresponsibly, ac-
cidents and serious injuries can occur. The
system is not a replacement for driver aware-
ness.
●
Before changing lanes, make sure it is safe
to do so. In particular, rapidly approaching
objects may not be detected in time.
●
Keep your hands on the steering wheel at
all times and be prepared to control your own
speed and direction of travel.
Turning o the lane change assist
1.
Briey press the button .
OR: Press the brake pedal.
Lane change assist is deactivated. Travel
Assist is also deactivated.
Troubleshooting
Travel Assist is not available or does not
work as expected
The control lamp switches on yellow. A rele-
vant warning is also displayed on the instru-
ment panel screen.
●
There is a fault in the sensors. Check the
causes and solutions described in the informa-
tion about the ACC ›››page167 or Lane As-
sist ›››page176.
●
There is a fault or a defect. Turn the drive
system o and on again.
●
The system limits are exceeded.
●
If the problem persists, consult a specialised
workshop. CUPRA recommends visiting a spe-
cialised CUPRA dealer or any SEAT dealership.
Grip the steering wheel
The warning lamp lights up white, and a mes-
sage is shown on the instrument cluster dis-
play.
●
You released the steering wheel for a few
seconds. Take hold of the steering wheel and
take control of the vehicle.
Grip the steering wheel
The warning lamp lights up red and a message
is shown on the instrument cluster display. De-
pending on the situation, an audio warning
sounds or the steering wheel vibrates.