Cupra BORN 2022 - Charging Cable

84
High-voltage battery
Note
Depending on the power supplied by the so-
lar installation and the household's instan-
taneous electricity consumption, the charg-
ing process may start earlier than usual and
continue later. If necessary, the vehicle au-
tomatically regulates the available charging
phases for safety reasons.
Current monitor
The instantaneous current ow in the home
is monitored. Before overloading the house’s
power grid, the vehicle automatically reduces
the charging current.
Bidirectional Charging
Prerequisites
●
Vehicle with 77 kWh net battery capacity.
●
Compatible home energy management sys-
tem (HEMS) and two-directional DC charging
station.
●
A charging location (Routine) has been cre-
ated in the Infotainment system.
Note
Ask specialist personnel for conrmation
about a suitable home energy management
system. It is recommended to use a CUPRA
partner.
Functionality
The home energy management system con-
trols the high-voltage battery charging or dis-
charging process, as necessary.
In the Infotainment system you can choose
between the charging modes Bi-directional
charging (charging and discharging) and dis-
charging (discharging only) of the high-volt-
age battery.
To limit the energy transferred, set the battery
charge levels in the Infotainment system. The
lower battery charge level is limited to 20% for
technical reasons.
It is not possible to schedule a charge for a
departure time.
In addition, the home energy management
system can use electricity from the high-volt-
age battery in the event of a power failure or to
power a home without a grid connection.
Note
Read and follow the home energy manage-
ment system’s user and operating manual.
Selecting the charging mode
1. Press the drop-down list of charging
modes and select Bi-directional Charging
or Discharging ›››page80.
The charging or discharging process starts
automatically.
2. Check the desired battery charge level in
the charging routine prole.
Note
●
It can read the amount of power drawn
from the home energy management system.
The vehicle discharges with a maximum
power of around 10kW.
●
The use of the function is limited to avoid
excessive wear of the high voltage battery.
When the maximum values on the operat-
ing hours meter (4,000h) and energy quan-
tity meter (10,000kWh) have been reached
in the Settingsmenu, contact the technical
service.
Charging cable
Introduction
The type of charging cable supplied with the
vehicle depends on the delivery volume and
the specic technical specications of each
country, e.g. charging connector connections
for power sockets.
CUPRA recommends exclusively using the
supplied charging cable.